diff options
Diffstat (limited to 'drivers/mtd/nand/fsmc_nand.c')
| -rw-r--r-- | drivers/mtd/nand/fsmc_nand.c | 49 |
1 files changed, 49 insertions, 0 deletions
diff --git a/drivers/mtd/nand/fsmc_nand.c b/drivers/mtd/nand/fsmc_nand.c index 567eff0..e0e9e1e 100644 --- a/drivers/mtd/nand/fsmc_nand.c +++ b/drivers/mtd/nand/fsmc_nand.c @@ -390,6 +390,55 @@ static int fsmc_read_page_hwecc(struct mtd_info *mtd, struct nand_chip *chip, return 0; } +#ifndef CONFIG_SPL_BUILD +/* + * fsmc_nand_switch_ecc - switch the ECC operation between different engines + * + * @eccstrength - the number of bits that could be corrected + * (1 - HW, 4 - SW BCH4) + */ +int fsmc_nand_switch_ecc(uint32_t eccstrength) +{ + struct nand_chip *nand; + struct mtd_info *mtd; + int err; + + /* + * This functions is only called on SPEAr600 platforms, supporting + * 1 bit HW ECC. The BCH8 HW ECC (FSMC_VER8) from the ST-Ericsson + * Nomadik SoC is currently supporting this fsmc_nand_switch_ecc() + * function, as it doesn't need to switch to a different ECC layout. + */ + mtd = &nand_info[nand_curr_device]; + nand = mtd->priv; + + /* Setup the ecc configurations again */ + if (eccstrength == 1) { + nand->ecc.mode = NAND_ECC_HW; + nand->ecc.bytes = 3; + nand->ecc.strength = 1; + nand->ecc.layout = &fsmc_ecc1_layout; + nand->ecc.calculate = fsmc_read_hwecc; + nand->ecc.correct = nand_correct_data; + } else if (eccstrength == 4) { + /* + * .calculate .correct and .bytes will be set in + * nand_scan_tail() + */ + nand->ecc.mode = NAND_ECC_SOFT_BCH; + nand->ecc.strength = 4; + nand->ecc.layout = NULL; + } else { + printf("Error: ECC strength %d not supported!\n", eccstrength); + } + + /* Update NAND handling after ECC mode switch */ + err = nand_scan_tail(mtd); + + return err; +} +#endif /* CONFIG_SPL_BUILD */ + int fsmc_nand_init(struct nand_chip *nand) { static int chip_nr; |