summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2016-06-12arm: at91: dts: Bring in device tree file for AT91SAM9G45Simon Glass
2016-06-12net: macb: Convert to driver modelSimon Glass
2016-06-12net: macb: Flush correct cache portion when sendingSimon Glass
2016-06-12net: macb: Prepare for driver-model conversionSimon Glass
2016-06-12net: Handle an empty bootp extension sectionAndre Renaud
2016-06-12bootm: Align cache flush end address correctlySimon Glass
2016-06-12arm: Allow skipping of low-level init with I-cache onSimon Glass
2016-06-12at91: Add support for the AT91 slow clock controllerAndre Renaud
2016-06-12gpio: at91: Fix pullup/pulldown configuration on PIO3Marek Vasut
2016-06-12verified-boot: Minimal support for booting U-Boot proper from SPLTeddy Reed
2016-06-12ti_armv7_common: env: Remove no longer needed mem_reserveAndrew F. Davis
2016-06-12cmd: gpt: add - partition size parsingMichael Trimarchi
2016-06-12arm: dra7xx: Assign omap_vcores based on board typeKeerthy
2016-06-12Merge branch 'master' of http://git.denx.de/u-boot-sunxiTom Rini
2016-06-12Merge branch 'master' of git://git.denx.de/u-boot-mipsTom Rini
2016-06-12Merge branch 'master' of git://www.denx.de/git/u-boot-imxTom Rini
2016-06-12Merge branch 'master' of git://git.denx.de/u-boot-x86Tom Rini
2016-06-12x86: broadwell: gpio: Remove the codes to set up pin controlBin Meng
2016-06-12x86: Probe pinctrl driver in cpu_init_r()Bin Meng
2016-06-12x86: Enable regmap and syscon for coreboot and qemu-x86Bin Meng
2016-06-12x86: Update x86-pinctrl driver device-tree-bindings docBin Meng
2016-06-12x86: baytrail: Configure card detect pin of the SD controllerBin Meng
2016-06-12x86: baytrail: Change fsp, emmc-boot-mode to "auto"Bin Meng
2016-06-12x86: baytrail: Add 'reg' property in the pinctrl nodeBin Meng
2016-06-12x86: ich6_gpio: Output return value of syscon_get_by_driver_data()Bin Meng
2016-06-12x86: acpi: Fix madt lapic generationGeorge McCollister
2016-06-10armv8: ls2080aqds: Enable QSPI boot supportYuan Yao
2016-06-10configs: ls2080aqds_nand_defconfig: Enable QSPIYuan Yao
2016-06-10configs: ls2080a: Increase load image len in NAND bootYuan Yao
2016-06-10armv8: ls2080aqds: Config QSPI pin mux via FPGA in NAND bootYuan Yao
2016-06-10dts: ls2080aqds: Add QSPI dts nodeYuan Yao
2016-06-10configs: ls2080aqds: Enable QSPI flash supportYuan Yao
2016-06-10armv8: ls2080aqds: disable IFC NOR & QIXIS when QSPI enableYuan Yao
2016-06-10configs: ls2080a_common: Remove duplicate NOR configsYuan Yao
2016-06-10armv8: ls2080aqds: Select QSPI CLK div via SCFGYuan Yao
2016-06-10drivers: i2c: mxc: Add early initYuan Yao
2016-06-10board: ls2080a: Add "mcinitcmd" env for MC & DPL deploymentPratiyush Mohan Srivastava
2016-06-10armv8/ls2080a: configure PMU's PCTBENR to enable WDTYunhui Cui
2016-06-10sunxi: Move the SPL stack top to 0x1A000 on Allwinner A64/A80Siarhei Siamashka
2016-06-10sunxi: Downclock AHB1 to 100MHz on Allwinner A64Siarhei Siamashka
2016-06-10spi: pic32_spi: add SPI master driver for PIC32 SoC.Purna Chandra Mandal
2016-06-10MIPS: Make CONFIG_SYS_DCACHE_LINE_SIZE int, not hexPaul Burton
2016-06-10MIPS: Fix invalidate_dcache_range to operate on L1 DcachePaul Burton
2016-06-10sunxi: musb: Properly turn of musb controller before bootingHans de Goede
2016-06-10sunxi: Add INITIAL_USB_SCAN_DELAY to Mele_A1000G_quad_defconfigHans de Goede
2016-06-10sunxi: Enable ALDO3 and ALDO4 in Wobo_i5_defconfigHans de Goede
2016-06-09siemens,am33x: add draco etamin boardHeiko Schocher
2016-06-09dfu, nand, ubi: fix erasing after write finishHeiko Schocher
2016-06-09am335x, dxr2: get ECC sType from I2C eepromHeiko Schocher
2016-06-09mtd: nand: omap: allow to switch to BCH16Heiko Schocher
generated by cgit v0.10.2 at 2024-08-01 23:41:11 (GMT)