u-boot - NXP/Freescale LSDK U-boot tree with Scalys patches

Age	Commit message (Expand)	Author
2016-04-04	ARM64: zynqmp: Enable FAT write and EXT4 write for USB too	Michal Simek
2016-04-04	ARM64: zynqmp: Decrease boot delay	Soren Brinkmann
2016-04-04	net: axi_emac: Report phy-node error message permanently	Michal Simek
2016-04-04	microblaze: Remove !OF_CONTROL code for timer and interrupt	Michal Simek
2016-04-04	microblaze: Read information about timer/interrupts from DT	Michal Simek
2016-04-04	ARM: zynq: Fix default ps7_init_gpl.c/h for ZYBO	Michal Simek
2016-04-04	ARM: zynq: zybo: Enabling reading MAC address from EEPROM	Michal Simek
2016-04-04	net: gem: Allow to set the MAC from an EEPROM	Joe Hershberger
2016-04-04	ARM: zynq: Enable option to overwrite default variables	Michal Simek
2016-04-04	net: xilinx_axi: Clear Isolate bit if found during phy setup	Siva Durga Prasad Paladugu
2016-04-04	net: xilinx_axi: Use interface type instead of zero	Siva Durga Prasad Paladugu
2016-04-04	zynq-common: Enable phy driver for Xilinx PCS/PMA core	Siva Durga Prasad Paladugu
2016-04-04	net: zynq_gem: Add support for SGMII interface	Siva Durga Prasad Paladugu
2016-04-04	phy: Add phy driver support for xilinx PCS/PMA core	Siva Durga Prasad Paladugu
2016-04-02	net: phy: Realtek RTL8211B/C PHY ID fix	Karsten Merker
2016-04-02	MAINTAINERS: Update Scott Wood's email address	Scott Wood
2016-04-01	sata: use block layer for sata command	Eric Nelson
2016-04-01	mmc: use block layer in mmc command	Eric Nelson
2016-04-01	drivers: block: add block device cache	Eric Nelson
2016-04-01	Add myself as Snapdragon and SPMI maintainer	Mateusz Kulikowski
2016-04-01	board: Add Qualcomm Dragonboard 410C support	Mateusz Kulikowski
2016-04-01	arm: Add support for Qualcomm Snapdragon family	Mateusz Kulikowski
2016-04-01	gpio: Add support for Qualcomm PM8916 gpios	Mateusz Kulikowski
2016-04-01	pmic: Add support for Qualcomm PM8916 PMIC	Mateusz Kulikowski
2016-04-01	drivers: spmi: Add support for Qualcomm SPMI bus driver	Mateusz Kulikowski
2016-04-01	spmi: Add sandbox test driver	Mateusz Kulikowski
2016-04-01	drivers: Add SPMI bus uclass	Mateusz Kulikowski
2016-04-01	ehci: Add support for Qualcomm EHCI	Mateusz Kulikowski
2016-04-01	ehci-ci.h: drop generic USBCMD fields	Mateusz Kulikowski
2016-04-01	usb: ehci-ci: Add missing registers.	Mateusz Kulikowski
2016-04-01	usb: Rename ehci-fsl.h to ehci-ci.h	Mateusz Kulikowski
2016-04-01	eth: asix88179: Print packet length properly	Mateusz Kulikowski
2016-04-01	usb: ulpi: Fix compile warning in read/write on 64-bit machines.	Mateusz Kulikowski
2016-04-01	usb: ulpi: Fix viewport_addr type	Mateusz Kulikowski
2016-04-01	Migrate CONFIG_ULPI* to Kconfig	Mateusz Kulikowski
2016-04-01	usb: ulpi: Add Kconfig options for ULPI	Mateusz Kulikowski
2016-04-01	ehci-hcd: Add init_after_reset	Mateusz Kulikowski
2016-04-01	mmc: Add support for Qualcomm SDHCI controller	Mateusz Kulikowski
2016-04-01	gpio: Add support for Qualcomm gpio controller	Mateusz Kulikowski
2016-04-01	serial: Add support for Qualcomm serial port	Mateusz Kulikowski
2016-04-01	board: ti: DRA7: Add DP83867 TI phy for rev c	Dan Murphy
2016-04-01	efi_loader: Always allocate the highest available address	Alexander Graf
2016-04-01	sniper: Change vendor name from lge to lg, matching devicetree vendor prefix	Paul Kocialkowski
2016-04-01	kc1: Proper reboot mode and boot reason validation	Paul Kocialkowski
2016-04-01	sniper: Proper reboot mode and boot reason validation	Paul Kocialkowski
2016-04-01	kc1: Add some sysboot and devicetree-related environment variables	Paul Kocialkowski
2016-04-01	kc1: Select libfdt to allow running devicetree-based kernels	Paul Kocialkowski
2016-04-01	kc1: Include explicit serial baudrate on bootargs	Paul Kocialkowski
2016-04-01	sniper: Include explicit serial baudrate on bootargs	Paul Kocialkowski
2016-04-01	arm64: booti: add missing unmap_sysmem()	Masahiro Yamada