summaryrefslogtreecommitdiff
path: root/board/freescale/mpc8569mds/bcsr.h
AgeCommit message (Collapse)Author
2009-10-27mpc85xx: Configure QE USB for MPC8569E-MDS boardsAnton Vorontsov
Setup QE pin multiplexing for USB function, configure needed BCSRs and add some fdt fixups. Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2009-10-27mpc85xx: Configure QE UART for MPC8569E-MDS boardsAnton Vorontsov
To make QE UART usable by Linux we should setup pin multiplexing and turn UCC2 Ethernet node into UCC2 QE UART node. Also, QE UART is mutually exclusive with UART0, so we can't enable it if eSDHC is in 4-bits mode on pilot boards, or if it's a prototype board with eSDHC in 1- or 4-bits mode. Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2009-10-27mpc85xx: Add eSDHC support for MPC8569E-MDS boardsAnton Vorontsov
eSDHC is mutually exlusive with UART0 (in 4-bits mode) and I2C2 (in 1-bit mode). When eSDHC is used, we should switch u-boot console to UART1, and make the proper device-tree fixups. Because of an erratum in prototype boards it is impossible to use eSDHC without disabling UART0 (which makes it quite easy to 'brick' the board by simply issung 'setenv hwconfig esdhc', and not able to interact with U-Boot anylonger). So, but default we assume that the board is a prototype, which is a most safe assumption. There is no way to determine board revision from a register, so we use hwconfig. Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2009-07-29Update Freescale copyrights to remove "All Rights Reserved"Kumar Gala
"All Rights Reserved" conflicts with the GPL. Signed-off-by: Kumar Gala <kumar.gala@freescale.com>
2009-06-1285xx: Add RMII support for MPC8569MDSHaiying Wang
This patch supports UCC working at RMII mode on PIB board, fixup fdt blob to support rmii in kernel. It also changes the name of enable_mpc8569mds_qe_mdio to enalbe_mpc8569mds_qe_uec which is more accurate. Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2009-03-30MPC85xx: Add MPC8569MDS board supportHaiying Wang
This patch adds MPC8569MDS board support. The UART, QE UEC1 and UEC2, BRD EEPROM on I2C2 bus, PCI express and DDR3 SPD are supported in this patch. Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com> Signed-off-by: Hillel Avni <Hillel.Avni@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>