Merge branch 'master' of git://git.denx.de/u-boot-arm

* 'master' of git://git.denx.de/u-boot-arm:
  ARM926EJS: Fix cache.c to comply with checkpatch.pl
  ARM926EJS: Make asm routines volatile in cache ops
  MX35: mx35pdk: wrong board revision
  ARM1136: MX35: Make asm routines volatile in cache ops
  ARM: add u-boot.imx as target for i.MX SOCs
  M28: Pull out CONFIG_APBH_DMA so it's always enabled
  DMA: Split the APBH DMA init into block and channel init
  imx: Return gpio_set_value in gpio_direction_output
  imx: Use GPIO_TO_PORT macro in the gpio driver instead of (gpio >> 5)
  imx: Add GPIO_TO_PORT macro in the mxc_gpio driver
  imx: Remove unneeded/repititive definitions from imx headers
  i.MX28: Allow coexistence of PIO and DMA mode for SD/MMC
  MX31: mx31pdk: drop enable_caches from board file
  i.MX28: Fix initial stack pointer position
  mx35: mx35pdk: fix when cache functions are linked
  mx35: flea3: fix when cache functions are linked
  ARM: 926ejs: use debug() for misaligned addresses
  ARM1136: add cache flush and invalidate operations
  mx6qsabrelite: Fix the serial console port
  mx6qsabrelite: Add boot switch setting information into the README
  i.MX6: mx6qsabrelite: add cache commands if cache is enabled
  i.MX6: implement enable_caches()
  i.MX6: define CACHELINE_SIZE
  MX53: DDR: Fix ZQHWCTRL field TZQ_CS
  mx28evk: Add a README file
  mx28: Split the README into a common part and a m28 specific part
  tricorder: Load kernel from ubifs
  tricorder: Add UBIFS
  cm-t35: fix Ethernet reset timing
  hawkboard: Add CONFIG_SPL_LIBGENERIC_SUPPORT
  BeagleBoard: Remove userbutton command and use gpio command instead
  OMAP: Move omap1510inn to Unmaintained / Orphaned

1 files changed, 17 insertions, 21 deletions

diff --git a/drivers/dma/apbh_dma.c b/drivers/dma/apbh_dma.c
index c086629..cb2193e 100644
--- a/drivers/dma/apbh_dma.c
+++ b/drivers/dma/apbh_dma.c
@@ -316,7 +316,7 @@ static int mxs_dma_request(int channel)
  * The channel will NOT be released if it's marked "busy" (see
  * mxs_dma_enable()).
  */
-static int mxs_dma_release(int channel)
+int mxs_dma_release(int channel)
 {
 	struct mxs_dma_chan *pchan;
 	int ret;
@@ -552,12 +552,10 @@ int mxs_dma_go(int chan)
 /*
  * Initialize the DMA hardware
  */
-int mxs_dma_init(void)
+void mxs_dma_init(void)
 {
 	struct mx28_apbh_regs *apbh_regs =
 		(struct mx28_apbh_regs *)MXS_APBH_BASE;
-	struct mxs_dma_chan *pchan;
-	int ret, channel;
 
 	mx28_reset_block(&apbh_regs->hw_apbh_ctrl0_reg);
 
@@ -576,28 +574,26 @@ int mxs_dma_init(void)
 	writel(APBH_CTRL0_APB_BURST_EN,
 		&apbh_regs->hw_apbh_ctrl0_clr);
 #endif
+}
 
-	for (channel = 0; channel < MXS_MAX_DMA_CHANNELS; channel++) {
-		pchan = mxs_dma_channels + channel;
-		pchan->flags = MXS_DMA_FLAGS_VALID;
-
-		ret = mxs_dma_request(channel);
+int mxs_dma_init_channel(int channel)
+{
+	struct mxs_dma_chan *pchan;
+	int ret;
 
-		if (ret) {
-			printf("MXS DMA: Can't acquire DMA channel %i\n",
-				channel);
+	pchan = mxs_dma_channels + channel;
+	pchan->flags = MXS_DMA_FLAGS_VALID;
 
-			goto err;
-		}
+	ret = mxs_dma_request(channel);
 
-		mxs_dma_reset(channel);
-		mxs_dma_ack_irq(channel);
+	if (ret) {
+		printf("MXS DMA: Can't acquire DMA channel %i\n",
+			channel);
+		return ret;
 	}
 
-	return 0;
+	mxs_dma_reset(channel);
+	mxs_dma_ack_irq(channel);
 
-err:
-	while (--channel >= 0)
-		mxs_dma_release(channel);
-	return ret;
+	return 0;
 }