diff options
Diffstat (limited to 'doc')
-rw-r--r-- | doc/driver-model/serial-howto.txt | 58 |
1 files changed, 58 insertions, 0 deletions
diff --git a/doc/driver-model/serial-howto.txt b/doc/driver-model/serial-howto.txt new file mode 100644 index 0000000..60483a4 --- /dev/null +++ b/doc/driver-model/serial-howto.txt @@ -0,0 +1,58 @@ +How to port a serial driver to driver model +=========================================== + +About 16 of 33 serial drivers have been converted as at September 2015. It +is time for maintainers to start converting over the remaining serial drivers: + + altera_jtag_uart.c + altera_uart.c + arm_dcc.c + lpc32xx_hsuart.c + mcfuart.c + mxs_auart.c + opencores_yanu.c + serial_bfin.c + serial_imx.c + serial_lpuart.c + serial_max3100.c + serial_pxa.c + serial_s3c24x0.c + serial_sa1100.c + serial_stm32.c + serial_xuartlite.c + usbtty.c + +You should complete this by the end of January 2016. + +Here is a suggested approach for converting your serial driver over to driver +model. Please feel free to update this file with your ideas and suggestions. + +- #ifdef out all your own serial driver code (#ifndef CONFIG_DM_SERIAL) +- Define CONFIG_DM_SERIAL for your board, vendor or architecture +- If the board does not already use driver model, you need CONFIG_DM also +- Your board should then build, but will not boot since there will be no serial + driver +- Add the U_BOOT_DRIVER piece at the end (e.g. copy serial_s5p.c for example) +- Add a private struct for the driver data - avoid using static variables +- Implement each of the driver methods, perhaps by calling your old methods +- You may need to adjust the function parameters so that the old and new + implementations can share most of the existing code +- If you convert all existing users of the driver, remove the pre-driver-model + code + +In terms of patches a conversion series typically has these patches: +- clean up / prepare the driver for conversion +- add driver model code +- convert at least one existing board to use driver model serial +- (if no boards remain that don't use driver model) remove the old code + +This may be a good time to move your board to use device tree also. Mostly +this involves these steps: + +- define CONFIG_OF_CONTROL and CONFIG_OF_SEPARATE +- add your device tree files to arch/<arch>/dts +- update the Makefile there +- Add stdout-path to your /chosen device tree node if it is not already there +- build and get u-boot-dtb.bin so you can test it +- Your drivers can now use device tree +- For device tree in SPL, define CONFIG_SPL_OF_CONTROL |