diff options
Diffstat (limited to 'arch/sh/Kconfig')
| -rw-r--r-- | arch/sh/Kconfig | 91 |
1 files changed, 64 insertions, 27 deletions
diff --git a/arch/sh/Kconfig b/arch/sh/Kconfig index 2121fbb..82868fe 100644 --- a/arch/sh/Kconfig +++ b/arch/sh/Kconfig @@ -9,11 +9,10 @@ config SUPERH def_bool y select EMBEDDED select HAVE_CLK - select HAVE_IDE - select HAVE_LMB + select HAVE_IDE if HAS_IOPORT + select HAVE_MEMBLOCK select HAVE_OPROFILE select HAVE_GENERIC_DMA_COHERENT - select HAVE_IOREMAP_PROT if MMU select HAVE_ARCH_TRACEHOOK select HAVE_DMA_API_DEBUG select HAVE_DMA_ATTRS @@ -22,6 +21,7 @@ config SUPERH select HAVE_KERNEL_GZIP select HAVE_KERNEL_BZIP2 select HAVE_KERNEL_LZMA + select HAVE_KERNEL_LZO select HAVE_SYSCALL_TRACEPOINTS select RTC_LIB select GENERIC_ATOMIC64 @@ -35,6 +35,7 @@ config SUPERH32 def_bool ARCH = "sh" select HAVE_KPROBES select HAVE_KRETPROBES + select HAVE_IOREMAP_PROT if MMU && !X2TLB select HAVE_FUNCTION_TRACER select HAVE_FTRACE_MCOUNT_RECORD select HAVE_DYNAMIC_FTRACE @@ -42,6 +43,9 @@ config SUPERH32 select HAVE_FTRACE_NMI_ENTER if DYNAMIC_FTRACE select HAVE_FUNCTION_GRAPH_TRACER select HAVE_ARCH_KGDB + select HAVE_HW_BREAKPOINT + select HAVE_MIXED_BREAKPOINTS_REGS + select PERF_EVENTS if HAVE_HW_BREAKPOINT select ARCH_HIBERNATION_POSSIBLE if MMU config SUPERH64 @@ -78,11 +82,12 @@ config GENERIC_HARDIRQS config GENERIC_HARDIRQS_NO__DO_IRQ def_bool y -config GENERIC_IRQ_PROBE +config IRQ_PER_CPU def_bool y -config IRQ_PER_CPU +config SPARSE_IRQ def_bool y + depends on SUPERH32 config GENERIC_GPIO def_bool n @@ -153,7 +158,6 @@ config LOCKDEP_SUPPORT config HAVE_LATENCYTOP_SUPPORT def_bool y - depends on !SMP config ARCH_HAS_ILOG2_U32 def_bool n @@ -170,6 +174,9 @@ config ARCH_HAS_DEFAULT_IDLE config ARCH_HAS_CPU_IDLE_WAIT def_bool y +config NO_IOPORT + bool + config IO_TRAPPED bool @@ -179,6 +186,12 @@ config DMA_COHERENT config DMA_NONCOHERENT def_bool !DMA_COHERENT +config NEED_DMA_MAP_STATE + def_bool DMA_NONCOHERENT + +config NEED_SG_DMA_LENGTH + def_bool y + source "init/Kconfig" source "kernel/Kconfig.freezer" @@ -230,6 +243,8 @@ config CPU_SHX2 config CPU_SHX3 bool select DMA_COHERENT + select SYS_SUPPORTS_SMP + select SYS_SUPPORTS_NUMA config ARCH_SHMOBILE bool @@ -446,18 +461,12 @@ config CPU_SUBTYPE_SH7786 select CPU_SH4A select CPU_SHX3 select CPU_HAS_PTEAEX - select ARCH_SPARSEMEM_ENABLE - select SYS_SUPPORTS_NUMA - select SYS_SUPPORTS_SMP select GENERIC_CLOCKEVENTS_BROADCAST if SMP config CPU_SUBTYPE_SHX3 bool "Support SH-X3 processor" select CPU_SH4A select CPU_SHX3 - select ARCH_SPARSEMEM_ENABLE - select SYS_SUPPORTS_NUMA - select SYS_SUPPORTS_SMP select GENERIC_CLOCKEVENTS_BROADCAST if SMP # SH4AL-DSP Processor Support @@ -548,8 +557,7 @@ config SH_PCLK_FREQ CPU_SUBTYPE_SH7203 || \ CPU_SUBTYPE_SH7206 || \ CPU_SUBTYPE_SH7263 || \ - CPU_SUBTYPE_MXG || \ - CPU_SUBTYPE_SH7786 + CPU_SUBTYPE_MXG default "60000000" if CPU_SUBTYPE_SH7751 || CPU_SUBTYPE_SH7751R default "66000000" if CPU_SUBTYPE_SH4_202 default "50000000" @@ -563,7 +571,8 @@ config SH_CLK_CPG config SH_CLK_CPG_LEGACY depends on SH_CLK_CPG - def_bool y if !CPU_SUBTYPE_SH7785 && !ARCH_SHMOBILE + def_bool y if !CPU_SUBTYPE_SH7785 && !ARCH_SHMOBILE && \ + !CPU_SUBTYPE_SH7786 config SH_CLK_MD int "CPU Mode Pin Setting" @@ -627,7 +636,7 @@ config KEXEC config CRASH_DUMP bool "kernel crash dumps (EXPERIMENTAL)" - depends on SUPERH32 && EXPERIMENTAL + depends on SUPERH32 && EXPERIMENTAL && BROKEN_ON_SMP help Generate crash dump after being started by kexec. This should be normally only set in special crash dump kernels @@ -699,6 +708,13 @@ config NR_CPUS This is purely to save memory - each supported CPU adds approximately eight kilobytes to the kernel image. +config HOTPLUG_CPU + bool "Support for hot-pluggable CPUs (EXPERIMENTAL)" + depends on SMP && HOTPLUG && EXPERIMENTAL + help + Say Y here to experiment with turning CPUs off and on. CPUs + can be controlled through /sys/devices/system/cpu. + source "kernel/Kconfig.preempt" config GUSA @@ -725,17 +741,7 @@ config GUSA_RB LLSC, this should be more efficient than the other alternative of disabling interrupts around the atomic sequence. -config SPARSE_IRQ - bool "Support sparse irq numbering" - depends on EXPERIMENTAL - help - This enables support for sparse irqs. This is useful in general - as most CPUs have a fairly sparse array of IRQ vectors, which - the irq_desc then maps directly on to. Systems with a high - number of off-chip IRQs will want to treat this as - experimental until they have been independently verified. - - If you don't know what to do here, say N. +source "drivers/sh/Kconfig" endmenu @@ -773,6 +779,17 @@ config ENTRY_OFFSET default "0x00010000" if PAGE_SIZE_64KB default "0x00000000" +config ROMIMAGE_MMCIF + bool "Include MMCIF loader in romImage (EXPERIMENTAL)" + depends on CPU_SUBTYPE_SH7724 && EXPERIMENTAL + help + Say Y here to include experimental MMCIF loading code in + romImage. With this enabled it is possible to write the romImage + kernel image to an MMC card and boot the kernel straight from + the reset vector. At reset the processor Mask ROM will load the + first part of the romImage which in turn loads the rest the kernel + image to RAM using the MMCIF hardware block. + choice prompt "Kernel command line" optional @@ -822,11 +839,15 @@ config MAPLE config PCI bool "PCI support" depends on SYS_SUPPORTS_PCI + select PCI_DOMAINS help Find out whether you have a PCI motherboard. PCI is the name of a bus system, i.e. the way the CPU talks to the other stuff inside your box. If you have PCI, say Y, otherwise N. +config PCI_DOMAINS + bool + source "drivers/pci/pcie/Kconfig" source "drivers/pci/Kconfig" @@ -864,4 +885,20 @@ source "security/Kconfig" source "crypto/Kconfig" +menuconfig VIRTUALIZATION + bool "Virtualization" + default n + ---help--- + Say Y here to get to see options for using your Linux host to run other + operating systems inside virtual machines (guests). + This option alone does not add any kernel code. + + If you say N, all options in this submenu will be skipped and disabled. + +if VIRTUALIZATION + +source drivers/virtio/Kconfig + +endif # VIRTUALIZATION + source "lib/Kconfig" |